American Eagle SHD-60 Bedienungshandbuch PDF herunterladen (Seite 9)

SHD-60AF Manual

Torque and Procedure Chart

Pulsation Chamber Assembly

Torque Value: 31 FT. LBS.

Procedure: See Head Installation Procedure Section

Head Assembly

Torque Value: 31 FT. LBS.

Procedure: Assemble head on the cylinder with head bolts started only, not tight. Snug (6) head bolts to light torque.

Tighten (6) head bolts to 31 Ft-lbs. torque, doing the (2) long center bolts first and the (4) short bolts last. After five

hours of use re-torque bolts to 31 Ft-lbs.

Cylinder Assembly

orque V

alue: 20 FT

. LBS.

Procedure: After assembling cylinder over pistons and setting into place, tighten (6) cap screws finger tight. In a

criss-cross pattern, tighten bolts evenly so all bolts are hand snug. Again in a criss-cross pattern torque each bolt to

20 Ft-lbs., checking each bolt twice.

After five hours of use, re-torque bolts to 20 Ft-lbs.

Connecting Rod

Assembly

Torque Value: 18 FT. LBS.

Procedure: Assemble rod onto the crankshaft taking care to align the machined surfaces together and tighten cap

screws finger tight. Tighten bolts until hand tight and torque to 18 Ft-lbs. Check twice the torque reading before final

assembly of the cylinders.

Hydraulic System:

The hydraulic system consists of the pump, oil

reservoir, filters and hoses. Installed on the

compressor is a valve block assembly that

controls the flow to the hydraulic motor. To this

block, a 1/2” high-pressure hose must be

attached. This hose comes from the hydraulic

pumps pressure side. A 3/4” minimum low-

pressure return line is connected to the oil

cooler outlet and is routed to the oil reservoir.

American Eagle recommends a sufficient sized

reservoir be provided which includes the proper

suction and return filters. The cooler on the

compressor is designed and sized to cool the

air compressor efficiently. An auxillary oil cooler

is required when additional hydraulically

Return Line

Pressure

Line

operated equipment are added to the hydraulic

system. Pressure on the return line exceeding

200 PSI can and will cause damage to the filter,

cooler, and components of the compressor

hydraulic system.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare

American Eagle SHD-60 Bedienungshandbuch Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Luftkompressoren American Eagle SHD-60