American Eagle SHD-60 Bedienungshandbuch PDF herunterladen (Seite 8)

SHD-60AF Manual

Installation

Pump Assembly:

The pump assembly may either be installed

directly on the PTO or as an optional method,

may be driven by a driveline from the PTO.

Pump manufacturers provide specific installation

information for their products and should be

consulted if questions arise.

PTO Assembly:

Check with the PTO manufactures

representative for specific instructions regarding

your particular make, model, and year of

vehicle. As some trucks may require

modification of the transmission cross member

and the exhaust system, the manufacturer’s

instructions should be followed to insure proper

installation of the PTO.

Compressor Assembly:

Prepare the mounting location of the

compressor by locating and drilling four (4)

holes, 7/16” diameter as per the mounting

pattern of the air compressor base. Using four

(4) 3/8” x 1.25 GR-5 cap screws, 3/8” flat

washers, and 3/8” nyloc nuts, secure the

compressor in place. The compressor is air

cooled, and must have a clean supply of cooling

air to the fan with minimum restrictions.

Adequate space must be provided for proper

circulation of air.

Electrical Connections:

From the air pressure switch there are two (2)

wires, red and black, running to the outside of

the compressor housing. Connect the black

wire to the vehicle frame or other suitable

ground. Mount a single throw toggle switch in a

convenient location and connect the red wire

from the compressor to this switch. Connect

the other switch terminal to a fuse holder and

then to a 12-volt power supply. A third wire is

required from the air compressor switch when

connecting the speed control into the system.

(See drawing below)

Electric speed control:

An optional electric or electronic speed control

must be used to maintain proper operating

speed of the air compressor. The engine speed

control will automatically increase from idle to

preset speed when engaged and decrease

when disengaged. The electric cable pull speed

control Stellar P/N C0873 is used on most

gasoline engines. The electronic speed controls

are used only on Ford 7.3 and 6.0L diesel

engines. Proper installation instructions are

provided with each system.

COMPONENT INSTALLATION

This section pertains to the installation of the air compressor, PTO, pump and other related items.

The instructions are intended as a guide to assist you with particular installation. These instructions

will provide only general information.

FAN

GND

CPRSR

SPD CTRL

PRESSURE

SWITCH

LINE

MOTOR

HYDRAULIC

MANIFOLD

COMPRESSOR (12V INPUT)

GROUND

SPEED CONTROL

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare

American Eagle SHD-60 Bedienungshandbuch Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Luftkompressoren American Eagle SHD-60